In stock

D12 La Audio Active Di Box


Two 9V batteries that are installed by removing the two screws from the panel can power the Di2. The battery types MN1604, PP3, and 6LR61 are suitable. There are no batteries supplied. The DI2's INPUT or LINK sockets accept jacks to turn on the device. The mating plug needs to be of the MONO kind to make sure this occurs. When a plug is plugged and electricity is provided, the blue LED turns on.


  • - Balanced and unbalanced outputs
  • - Link output
  • - Switches gain
  • - Input switching for instrument  or speaker input levels
  • - Ground lift switching


  • - Frequency Response: +4, -2dB, 20Hz to 20kHz
  • - Signal to Noise Ratio: -9dBu, 0dB switch position l -86dBu, +20dB switch position
  • - Distortion: <0.1%, 1kHz, 0dB switch position
  • - Input Impedance: 1M Ohm, Normal switch position l 10k Ohm, Pad switch position
  • - Output load (recommended): >300 Ohm, balanced output l >2l Ohm, unbalanced output
  • - Power requirements: 15V to 48V, Phantom power l 1mA, Phantom power current
  • - Output XLR Pin Assignment: Pin 1 = Gnd, Pin 2= Hot (signal+), Pin 3= Cold (Signal-)
More Information
Write Your Own Review
You're reviewing:D12 La Audio Active Di Box
To Top